Place the PYRO-ENERGEN on a sturdy flat surface (e.g. on a plastic/wooden table or desk), away from nearby conductive materials. It may be in your bedroom or living room. Plug the output cable to the Output High Voltage. Connect the alligator clip to a metal sheet, foil or screen. The cable from the PYRO-ENERGEN to metal screen should not be touching to the ground.

Place the metal screen or sheet on a low plastic stool. Sit on a plastic or wooden chair (plastic chair is most recommended for better insulation).Use only clean and dry plastic or wooden materials.Don’t use cane (bamboo or rattan) chairs as it could be poor insulators and could produce electrostatic leakage resulting to less effectiveness of the treatment.Place your feet (bare or with socks) on the metal sheet or screen.

Finally, have someone plug the power cord into the outlet.If you need to use the PYRO-ENERGEN alone, it is best to use it with a remote-controlled power outlet. If unavailable, one solution is to use a power extension bar that has a separate on and off switch, and use a plastic or wooden stick to turn on the switch.Be sure not to bring the power cord near the Output High Voltage terminal and cable. Do not touch any appliance or anything or anyone that is grounded.The two indicator lights should light, then, electrotherapy begins.

Children or pets may be held on the lap for treatment.

Treatment frequency of 3–5 times a day, at 30 minutes per session is adequate. If you do not suffer from an illness or disease, once a day or twice a week of treatment is recommended to prevent disease and maintain health.

After your session is completed, be sure to remove your feet first from the metal screen, then unplug the unit from the wall outlet, or turn off the power extension bar if you’re using one. Or, have someone turn off the machine for you.